I’m completely new to the Moai and resin printing and this may sound ridiculous but I can find out which power supply is for the Moai and which is for the heater. I ordered the printer assembled from Peopoly. Any info would be appreciated.
The larger power supply is for the heater. I added the heater later, so I never thought about mixing them up until you mentioned it. Probably a good idea to label them.
Thank you for clearing that up for me. I plugged in the larger one into the Moai for a minute before I thought that I was making a wrong assumption. Glad I checked before anything bad happened. I only ran the calibration test for a moment. Can’t see any damage at all and strangely enough the heater psu worked fine on the Moai for that minute. Maybe because both are 24v but I’m glad I asked. Best regards
It’s a good idea to label all your power bricks.