Warped vat problems


So the ‘loose’ vat that I had taped into placed (to avoid movement) appears to be warped. The diagonally opposite corners are low or high respectively. No amount of adjustment can counter this. Two corner are approx 10.6 when the others are 11.5 when printing the calibration towers. I have run multiple cycles. At time of purchase I bought 2 vats. One is fine, but the Pdms bubbled, so I only have one vat until I can get pdms to recoat. Anyone else had similar issues or am I just unlucky?


I have not had any simular issues but could you please send pictures of both vats.