Vat "stuck" after failed print


#1

I stopped a print today because it had failed. When I hit stop, the vat was in the process of tilting and I didn’t think it would be a problem. However, I can’t get the vat to tilt back to normal. I’ve tried power cycling. I’ve tried starting a new print. Neither works. Obviously new prints won’t work like this since the print won’t be touching the bed.

Is there a way to handle this other than opening the box and manually turning the screw myself?


#2

Never-mind. I hadn’t waited long enough in “OFF” while power cycling. A proper power cycle did the trick. Mods, feel free to delete this thread if you like.