Testing first ring print and not finishing


#1

Finally working on my first test prints for my Moai and I’m starting with the ring. The base is working just fine and it gets a bit into the supports before the print stops working. The printer continues on as normal laser firing and all, but its not attached anymore.
Also is there a way you all recommend to remove the resin that was lasered at the bottom of the vat?


#2

Sorry to hear your issue, here is a survey we use to help us get as much info as we can from user so that we could provide best solution. Even if you might have provide some info already, please answer the question for the completeness.

support question:

Room temperature (best to be >25C):

What type of resin:

Build plate type: (Standard 1-piece / easy to level)

Vat: (Silicon vat / FEP vat)

What type Vat: (Peopoly Original vat, Recoated Peopoly vat, custom vat made by user)

Leveling measurement:

A, B, C, D (example 10.9mm)

Firmware version:

System Setting is default per Peopoly recommendation? (Yes/No)

Laser Power:

Z-reset position:

PM Motor Speed:

Z Follow Speed:

Software used to slice?

If using Asura,what version and profiles

If using Cura, what version and Profiles:

Infill %:


#3

use the plastic spatula provided with the FEP kit to peel it off
also, you might want to re-organize your wire, they may get in the laser path


#4

what what you are saying is the print broke in half? the support offers good survey and it will help us troubleshoot your situation.