Siraya tech tenacious and FAST

I’m using phenom L, but I’m thinking of using siraya tech tenacious and FAST together to make mask
Please tell me the recommended ratio and parameters.

It can be mixed in any ratio, depending on your model requirements. It is recommended to use a mixture of 7:3 or 5:5. Exposure parameters can be printed directly using siraya tech Blu parameters. It has built-in parameter settings in the chitubox software.

1 Like

Support,

Would that be the same for Deft and Tenacious?

Thanks

It is the same, if it is mixed in a ratio of 50:50, you can also increase the exposure by 30% on the basis of the Deft resin exposure parameters for printing.

I wish I had seen this earlier, just printed 7:3 with Blue parameters. It looks ok.

Will 30% tenacious make much difference in reducing brightness?

The effect is not great, but the larger the tenacious ratio, the better the toughness of the model.