Set laser power via gcode


#1

Would be nice to be able to set the laser power via a gcode. Looking at the codes it would be even possible to alter it per layer (or per line), but I would be happy if we could set it per print.

It’s not uncommon to forget to change the laser power based on the resin you are using. Being able to add a code at the beginning of the file to set the laser power would be handy.


#2

This would be awesome. It would mean you can write a “half layer” by placing a low power outer wall layer.


#3

I’d be very interested in this feature too. Changing the laser power by gcode would give additional flexibility.
Are there any releases planned?