Resins for Peopoly Phenom Printer?

#1

Hi

Have a question to Peopoly.

Can I print these resins with my printer?

Deft Resin by Peopoly for Phenom

Peopoly Tough Resin

Nex Resin – Grey Hi-Temp

Nex Resin – Clear Hi-Temp

Siraya Tenacious

Siraya Blu

The prices are just per 1 / L with 70 € already
a little high, prices will be in the future
sink?

Thanks

#2

except for Nex resin and Peopoly tough, the other 3 should print fine
You can use LCD resins on SLAs but not the other way around
for siraya resin you would still need the print chamber to be warm (~25C ) to ensure the quality

#3

Hi

Yes, I will temper the pressure chamber to 25 degrees.

But is not it impossible to print the Nex High Temp with my Peopoly Phenom or ???

I have to print exactly this type of resin that I need parts that can withstand high temperatures.

Is there a hint how I could do it? Increase exposure time or something.

I look forward to your response.

#4

Siraya Sculpt can be printed on Phenom and it has a DHT 160C
Phenom is LCD printer so the power of the LCD panel is limited, SLA resin needs higher laser power to cure and the power is adjustable

#5

Okey Thanks for the info.

Can you tell me what shutter speed should I best use for these 3 resins?

Peopoly Deft Resin:
Layer height 25-50my
Floor exposure time?
Layer exposure time?
Dive hoist?

Siraya Sculpt Tenacious:
Layer height 25-50my
Floor exposure time?
Layer exposure time?
Dive hoist?

Siraya Blu:
Layer height 25-50my
Floor exposure time?
Layer exposure time?
Dive and lift feed?

#6

Can you give me the best possible print data for the 3 resins described above? And if possible, the data of Siraya Tech Sculptures I also bräuvvte to print.

Exposure time of the ground, exposure time of the individual layers, diving and lifting speed?

I hope you continue to help me with these 4 resins.

#7

There is a google sheet that has the settings that was used located here

#8

Siraya Tech has added parameters for their Fast resin for the Phenom.

60s for bottom layers.
12s for the rest.

#9

hi there…

some of the values in this sheet are different than the deft profile that is in the chitubox software.

Just two values are the different bottom lift and lifting distance. The sheet has 8 but the applications built-in deft profile has 8 and 12.
which are correct?