I am new to the forum and to SLA printing, but have had good success so far with standard Peopoly clear model resin. I adjusted my settings and tried to run Tough several times with no luck.
The first attempt yielded a thin layer of adhesion to the build plate, followed by the rest of the part curing in the vat.
I added more, thicker supports and upped the laser power by 1, to 54. This yielded more adhesion and it actually resembled a part, though still a big failure. See pictures for details of part and setup. I’m using the easy-level plate, the FEP vat and the Moai heater. I also let the chamber heat for about 30 minutes before beginning the print.
Any advice would be GREATLY appreciated.