Nothing is printing except a single layer on the vat

#1

I am having a problem where prints aren’t sticking to the base. Only a single layer is sticking to the vat. I also can’t seem to print the level test corner pegs anymore.

  • 75 Degrees
  • X Size 900
  • Y Size 900
  • X Deviation 100
  • Y Deviation 100
  • Smooth 50
  • Z Motor Speed 2
  • PM Motor Speed 15

Advanced Setting

  • Laser Power 58
  • XY Speed Set 4
  • Z Reset Position 1816
  • PM Reset Position 10
  • Z Follows 2
  • CompensateX 100
  • CompensateY 200
  • Z Initial Speed 2
  • PM Initial Speed 10
vat

0 Likes

#2

Which vat? I am guessing PDMS? Is that Z-reset correct? It seems rather high.

0 Likes

#3

is this the 1st line of the setting? it’s not temperature, it’s laser power even the standard resin only print at 58. this not only make the resin over cured but also destroy your vat

What is your resin type and build plate type?

0 Likes