My printing result~

#1

green one on the left side is made by a LCD printer~
orange one in the middle is made by a Chinese studio’s sla resin, but printed use moai
gray one on the right side is made by moai’s resin & machine

1 Like

#2

You seem to be getting really soft corners/edges on the Moai.
Did you take the protective film off both sides of the plastic galvo cover?
Have you checked for other problems that might be causing the laser spot to not be well focused?

0 Likes

#3

the orange on is printed by the moai, but not their resin. so I dont think it isn’t caused by my machine like the laser not focus, and I didn’t install the plastic cover~

0 Likes

#4

OK, so you’re getting reduced quality results on the gray resin for some reason.
I’ve been getting good 50 micron details from the peopoly gray resin, so I’m not sure why yours would lose details/edges.
The Orange looks a lot like the results I get with Monocure’s laser resin – very sharp edges/details.

0 Likes

#5

you are using the Moai version of Cura, not vanilla Cura from Ultimaker right?

0 Likes

#6

yep~ downloaded from peopoly

0 Likes

#7

more tests~~

1 Like

#8

really like this orange resin, it looks amazing almost like amber - can you tell me where you sourced it.

Great work by the way. I love the ring.

Jon

0 Likes