I’m trying to figure out how to replace the laser module in the Moai with a laser module using another wavelength for research purposes. I’ve been trying to figure out the best way to go about it. So the laser module in the Moai has four cables connected to it. The only laser modules I can find online only have either two connections:
or the ones that have TTL (which I assume is necessary) have three connections:
The two main questions I have are:
What would happen if I connected a laser module with less than four connections to the connector on the power board corresponding to the laser? I assume if the laser does not have TTL it might just keep firing continuously?
What kind of PCB connector does the Moai power board use? I have not been able to find connectors that will plug in there neatly.
I know it might be a bit of a tall order getting this to work but I would appreciate any help I can get!