Maximum PM Reset Position

#1

Hi There,

What’s the maximum amount I can put in the PM Reset Position value? I’m using a 3rd party FEP vat and I’d like to have it tilt a few more degrees than the suggested 60 setting. Reason being I’m not getting reliable peels on in the “green zone”. I feel like more tilt might help?

Cheers.

0 Likes

#2

100 is max and that is a lot of distance (see wiki for firmware settings). if that still does not work, maybe you need better film

0 Likes

#3

i usually print on red area. underneath the red area is the pulling motor.

0 Likes

#4

Thanks! I will have another try with the setting at 80. But yes, maybe it’s time to replace the film. It’s nearing 50 or 60 prints…

0 Likes

#5

Yes I know. I print in that region too. The problem is when a part is large enough that it strays too far into the green I sometimes have issues with FEP not peeling off all the way across the part.

0 Likes