Asura support generation problem

#1

Hi, I’m having problems when generating support on small objects.
Last time it was a tire with 20 mm diameter.
Loaded in Asura 2.2.1 and support generated automaticaly resulted in this:

I’m pretty sure this will not print correctly. Any idea how can I improve auto support generation?
Of course I have no problem to setup support manualy but just would like to know I’m not doing something wrong… :wink:

S.

0 Likes

#2

Try changing the angel (last box) from 46. Your model is not angled enough for Asura to make supports.

0 Likes

#3

Thanks a lot. It’s a lot better.
Is there any place where I can get information about all the Asura settings and what they are for?
Thx

0 Likes

#4

another way is too manually add the supports where you feel needed

0 Likes