Asura first layer velocity

#1

As you all know in cure you can set the speed of the first layers is always slower to ensure that the print stays well attached to the platform but I do not use cure and in asura I’m doing very well so I investigated a bit in the asura profiles to change to the speed of the first layer (with the risk that it takes off) modify the profile of 100um and this is the result:
in this case using the same stl the first layer with the normal profile of asura takes 43 min (it is a very long time) and with the modified profile takes 4 min, in this case it has adhered perfectly, it must be taken into account in the case that take off that 90% of the odds is that this is the fault especially in larger pieces with more suction.
made with beta 2.23 asura and excellent results
gfd
htrd


1 Like