Sorry if this is posted somewhere but I haven’t been able to find it. I just got the advanced acrylic plate for the fep vat and I was wondering what the ZReset was for it? 1816 is what I use for the standard fep vat.
I don’t believe there is any difference in height between the old and advanced acrylic plates. The difference comes in the holes around the face of the plate and (i’m not sure whether it was on the original or not. May have been) the pdms layer.
I have the advanced plate in my FEP vat from factory and I still use either 1816 or 1817
Testing is above studying.
Simply put four strips of paper in the corners and lower the building board to Z Reset.
The four strips should just barely move.
This also helps with leveling.
1816 is the recommended value but it will be somewhat different depending on the user’s leveling
Thank you all very much for responding to my post.