Adding an Interlock to the door

I am currently trying to add an interlock to the door so that whenever the door is opened, the print is paused / laser is shut off / or power is shut off. In order to do this, it would be very helpful to have an electrical schematic or electrical block diagram for the printer. Has anyone been able to get ahold of one?

Also, are you able to pause the print?

Thanks in advance

That’s a good idea and we will sure have them in our to-do list
You can pause the print and recover it to continue, the option should be shown on the Moai’s interface
the only thing is when you paused, the z won’t lift up so if your print haven’t reach layer 150-200, you won’t be able to see the progress
Adding the z-lift would cause more trouble than leaving it as it is