This section is for printing advice. Please post here if you have question prior to a print, for example if you don't know how to setup your support structure or which direction you should rotate your object for printing.
Have you tried any Resins or wanted to try and don't know where to start from? Post here with brand and type names and get some feedback from the community.
This is the place for all your Moai hardware questions and comments. It's all about the printer hardware, building questions and setup instructions.
Here's the place for all your software issues. Be aware that there are sub forums for Cura and Firmware. Please post these questions in there respective sub forums. This general software forum is for everything else.
Discussion about this site, its organization, how it works, and how we can improve it.