Printing advice


Topic Replies Created
Models not sticking on bed. help? 4 March 8, 2019
Model not finished 6 March 8, 2019
Printing failure 8 March 4, 2019
What is going wrong here 13 February 5, 2019
Hitemp Resin, What 've learned so far 18 October 9, 2018
Vat "stuck" after failed print 2 March 5, 2019
Prints too small 3 March 4, 2019
Calibration problem Y axis 11 February 24, 2019
Testing first ring print and not finishing 4 February 28, 2019
DIY TEST prints only 2 cylinders 8 February 18, 2019
Build plate starts in the air 9 September 2, 2018
Prints all detach after a few mm 4 February 24, 2019
Help me with calibration 20 February 9, 2019
Questions on Leveling with FEP vat and Easy to Level Buildplate 12 February 18, 2019
Small Bubbles on my prints 8 February 19, 2019
ChiTuBox for making supports 7 February 16, 2019
Distorted DIY height test pegs 4 February 15, 2019
Printing One item works, but multiple at once fail 13 February 3, 2019
Need help getting small round rings and tubes to print clean and accurate 21 February 11, 2019
Z axis not rising while printing 4 February 10, 2019
Warping along straight and flat planes 6 October 9, 2017
Banding, Ghosting, stepping lines 10 January 1, 2019
Air inside 100% filled parts 8 December 23, 2018
Moai says "printing first layer" but isn't doing anything! 12 January 31, 2019
Is this software or hardware? 17 January 28, 2019
Printing different object than what is in G-code 7 February 2, 2019
Not sure what's happening with my prints [Re-opened] 17 January 27, 2019
Print divide of the build plate 8 January 25, 2019
[Solved] Print failed when scaled up 10 January 28, 2019
Print missing layers. Part of print stuck on vat 23 December 11, 2018