Hardware


Topic Replies Activity
Control Wheel Failure 7 December 11, 2019
Build plate doesnt lower 4 December 9, 2019
Bubbles on the UV printing plate? 5 December 6, 2019
Holes in build plate 6 November 29, 2019
Resin in VAT's holes and burned film 11 November 29, 2019
"Bump" in calib circle 3 November 29, 2019
Print streched 5mm in X axis 4 November 25, 2019
Moai 200 holding onto old gcode 4 November 21, 2019
Print restarts at end/middle of print 5 November 19, 2019
Control Wheel's clicks not recognized 14 November 18, 2019
SD Card Reader wasted 2 November 17, 2019
Disortion problem on Moai 130 12 November 13, 2019
After circle test everything is still wack-o- 14 November 12, 2019
Moai 200 for sale in Seattle area 8 November 11, 2019
Moai 200 VAT Motor 2 November 11, 2019
Heater arrived and I can’t tell if it works 6 November 5, 2019
Laser power units 4 November 4, 2019
How can I check the print time after it's finish? 4 November 1, 2019
Starting with the FEP vat 6 October 26, 2019
Thin protective plastic on FEP vat acrylic 5 October 22, 2019
Installing FEP vat and calibration 2 October 21, 2019
Tilt Motor Grinding 10 October 17, 2019
Sanding easy to level Build Plate 9 October 16, 2019
Sd board replacement 2 October 16, 2019
Moai does not boot 10 October 11, 2019
Need Help With Calibration 13 October 10, 2019
Packaging was EXCELLENT 10 October 10, 2019
New Small Vat - For experimental resins 4 October 10, 2019
Z Reset Position with FET VAT and Easy Level Build Plate and Heavy Duty Z Axis Arm 2 October 9, 2019
First test run (moai circle) failing 3 October 9, 2019